No Products in the Cart
Homdum screwdriver Drill: is a power tool designed to insert and remove screws. it can also be used to drill holes in Brick wall , Wood and Metal sheets. The specifications., 220V, 50Hz, 280W, 0-750 Rpm.***Torque adjustment: When driving screws in the harder the material the lower speed and more torque you're likely to need. Getting these settings right helps you to control the depth of your drilling without causing any damage. When drilling holes the harder the material the higher the speed to get the best result.***Speed control 0-750 Rpm: Most drill/drivers have two speeds, but this one has multiple for an even finer adjustment. The adjustable gearing provides versatility based on the task you will be performing. Setting low speed/high torque is best for driving screws. Setting top speed/torque can be used for drilling.***Keyless drill chuck: It eliminate the need for a chuck key to open and close the jaws of the chuck. You simply hand tighten the chuck after inserting the drill bit or cutting tool into the space between the three jaws. Machinists and others who use drill chucks have a tendency to lose chuck keys, so this prevents that from happening; you do not use a chuck key to open or close the jaws of a keyless chuck. Over time the teeth of a keyed chuck can break or chip.***Reverse Forward Motion : screwdriver drill have a reverse feature, it can screw or drill in both directions. The reverse feature is controlled using a switch which allows you to alternate between forward and reverse. This switch is located just above the trigger, so it can be pushed easily with your thumb or forefinger. Removing screws If a screw has been driven in using a powered screwdriver, it can be hard to remove it using a manual screwdriver. The reverse feature can be used for this purpo***Note: Don't alternate between reverse and forward if the screwdriver drill is still running, wait until it has come to a complete stop. Also This is not a hammer drill.
